
Setting the Auto Pan Speed
1. Press and hold A/P key.
2. Move joystick to Pan Right until the desired speed is observed on the monitor.
3. Release the A/P key.
4. Release the joystick
Activating Auto Pan
Auto Pan allows the dome to continuously pan between the left and right scan limit settings. To start
Auto Pan, press the A/P key. If no scan limit settings are programmed, the dome pans to the right
continuously.
Note: Auto Pan will be cancelled if the operator issues a Pan, Flip, Preset, or
Pattern command.
Wiring Configurations
In Vicon systems where the domes support loop through, daisy chain the SpeedDome Ultra VII
domes off the last Vicon dome in the communications chain.
Figure F-1: SpeedDome Ultra VII dome loop-through wiring from Vicon dome
To controller or
other domes
In Out In Out
Command Response
Vicon dome
SpeedDome
SpeedDome
Vicon Protocol Command Summary F–5
Comentarios a estos manuales