
DeltaDome Programmable Surveillance Camera
8000-2616-01, Rev. D
INSTALLATION AND SERVICE GUIDE 41
Data Cable Requirements
Table 2 shows the data cable requirements for
SensorNet, RS422, and Manchester networks. For
more information about communication protocols
and cable networks, see Communication Protocols
and Cable Networks, 8000-2573-19.
Table 2. Data cable requirements
SensorNet RS422 Manchester
Cable
type
1
unshielded,
twisted pair*
2
shielded,
twisted
pair*
1
shielded
twisted pair**
Wire
gauge
22 AWG 22 AWG 18 AWG
Con-
nection
Non-
polarized
Polarized Polarized
Max.
devices
on line
32 10 3
* Power, data, and video cables can be ordered
separately or within a composite cable that can be
ordered in various lengths. All cables must be
plenum rated for indoor installations where cable is
routed above the ceiling. Order parts through your
distribution network.
Note: If you order cable from an outside source,
wire colors may be different.
** Belden 88760 (plenum), or Belden 8760 cable (non-
plenum) cable is recommended. Plenum-rated cable
is required for indoor installations where cable is
routed above the ceiling. Order cable directly from
Belden by calling 1-800-235-3361.
Install/Removal Tool for
ADIUB Base
The install/removal tool (Figure 9) enables you to
connect or disconnect the housing and eyeball
assembly from the ADIOB base with I/O board,
and to attach/detach skirts and bubbles to a top
hat housing, without the need for a ladder. The tool
attaches to a telescopic pole (purchased
separately). See page 20.
CAUTION: Do not use this tool to connect the
dome the ADPTB base.
Figure 9. RHIRT indoor install/removal tool
Telescopic Pole 08140
by Recreational Water
Products. See page 20
to order.
RHIRT Removal Tool
Comentarios a estos manuales