American Dynamics RAS918LSP Especificaciones descargar pdf (Pagina 30)

SPEEDDOME ULTRA VII EIS DAY/NIGHT CAMERA DOME 8200-0184-14, REV. A

INSTALLATION AND SERVICE GUIDE

30 of 37

The following steps refer to

Figure 34.

6. Access camera/lens board.

To do this, loosen captive retaining screw

holding bearing assembly in place and remove

this assembly.

7. Remove cables from camera/lens board.

a. Small amber ribbon cable is from tilt motor.

Unplug this cable from connector J3 on

camera/lens board.

b. Large gray ribbon cable is from slip ring

connector. Unplug this cable from connector

J2 on camera/lens board.

DO NOT unplug small white ribbon cable from

connector J1.

8. Push out on three prongs to detach camera/lens

board.

9. Reverse steps to reassemble.

Figure 34. Removing the camera/lens board

Removing the Tilt Motor

1. Perform procedure "Removing the Slot Covers"

(page

28).

2. Perform procedure "Removing the Camera"

(page

28).

3. Perform procedure "Detaching the Eyeball"

(page

29).

4. Separate yoke brackets (

Figure 35).

Figure 35. Separating the yoke brackets

5. Gently pry off yoke bracket covering pan

gear assembly to access tilt cable assembly

(

Figure 36).

Figure 36. Removing the yoke brackets

J3 (Pins on ribbon

cable must face

contacts on

connector.)

Prongs (3)

DO NOT unplug

cable from J1.

Bearing Assembly

Camera/Lens Board

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 36 37

Comentarios a estos manuales

Sin comentarios

American Dynamics RAS918LSP Especificaciones Pagina 30

Comentarios a estos manuales

Relacionado con productos y manuales para Cámaras De Seguridad American Dynamics RAS918LSP