American Dynamics RAS918LSP Especificaciones descargar pdf (Pagina 5)

SPEEDDOME ULTRA VII EIS DAY/NIGHT CAMERA DOME 8200-0184-14, REV. A

INSTALLATION AND SERVICE GUIDE

5 of 37

Outdoor Mounting (Optional)

Note: This document does not include outdoor

installation and service instructions. For these

instructions, see RHODUL Outdoor Housing Install

Guide 8200-0492-01.

The camera dome attaches to outdoor walls and

ceilings using an RHODUL outdoor housing

(

Figure 5) and an ROENDC end cap connected to

one of the following optional mounting structures

(

Figure 7)

• RHOTR Over Roof Mount

• RHOTRF Over Roof Floor Mount

• RHOPN Pendant Mount

• RHOWPA Pole Mount

• RHOSW/RHOLW Wall Mount

• RHOWCA Corner Bracket.

The outdoor housing contains a pre-installed

mounting base, a cooling fan for hot weather, a

heater for cool weather and to prevent icing, and

surge protection circuitry.

An environmental PC board is used to pre-wire

cables. A round spring-finger connector on the

board makes electrical contact with the housing

and eyeball assembly as it connects to the base.

Note: Do not use the I/O board (designed for

indoor use) in place of the environmental board.

Figure 5. RHODUL outdoor housing (optional)

SpeedDome Housing Adapter

Bracket (Optional)

An RHSDA adapter bracket (Figure 6) enables the

dome to fit into SpeedDome indoor housings

(RD500A). Locking pins in the bracket enable the

dome to swing out for servicing or removal.

Figure 6. RHSDA adapter bracket (to used with

the RD500A housing)

1 2 3 4 5 6 7 8 9 10 ... 36 37

Sin comentarios

American Dynamics RAS918LSP Especificaciones Pagina 5