American Dynamics RAS916LS-1 Especificaciones descargar pdf (Pagina 22)

SPEEDDOME ULTRA VII AND ULTRA VIIE CAMERA DOME 8200-0184-01, REV. E

INSTALLATION AND SERVICE GUIDE

22 of 38

7. Observe yellow comm. LED (CR28) on I/O

board (

Figure 22). Is the LED on or flashing?

YES Go to step 8.

NO Verify cable is properly attached by

referring to table in step 9, page 17. If OK,

replace I/O board or contact your sales

representative for repair instructions.

Figure 22. I/O board switch and LED locations

Comm. LED

Power LED

RS422 Test

Pushbutton

P1 connector (Manchester data)

Pin Color Designation

1-4 Not used.

5 Black Manchester (+)

6 White Manchester (–)

P1 connector (RS-422 data)

Pin Color Designation

1 Orange RS-422 Data In High (+)

2 Green RS-422 Data In Low (–)

3 Yellow RS-422 Data Out High (+)

4 Brown RS-422 Data Out Low (–)

5-6 — Not used.

P1 connector (SensorNet 485 data)

Pin Color Designation

1-4 — Not used.

5 Orange SensorNet 485

6 Yellow SensorNet 485

8. If using RS-422 network and an I/O board is

used, check comm. line connections by

pressing and holding data test switch SW1

(

Figure 22) and observing nearby red (CR34)

and green (CR35) LEDs. These LEDs indicate

the following:

Constant green,

Blinking red

Comm. line correctly

wired.

Constant green,

No red

"Data In -" shorted to

ground.

Constant red,

Blinking green

"Data In +/ -" wires

reversed.

Blinking red,

Green off

"Data In +" shorted to

ground.

Both LEDs off

"Data In +/ -" wires

shorted or open.

9. Check spring finger connector on I/O board by

connecting housing and eyeball assembly to

original base to verify contact between spring

fingers and CPU board (under cap). Does dome

produce video and respond to commands?

YES Spring fingers may not have seated

properly. Reconnect housing and eyeball

assembly.

NO Replace I/O board.

If routine troubleshooting did not solve the problem,

the manufacturer strongly recommends you

contact your sales representative for repair

instructions.

If you must perform detailed troubleshooting, use

extreme care when disassembling parts! See

"Detailed Troubleshooting," next.

SW1

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 37 38

Comentarios a estos manuales

Sin comentarios

American Dynamics RAS916LS-1 Especificaciones Pagina 22

Comentarios a estos manuales

Relacionado con productos y manuales para Cámaras De Seguridad American Dynamics RAS916LS-1