American Dynamics RAS916LS-1 Especificaciones descargar pdf (Pagina 36)

SPEEDDOME ULTRA VII AND ULTRA VIIE CAMERA DOME 8200-0184-01, REV. E

INSTALLATION AND SERVICE GUIDE

36 of 38

Appendix A: Checking Power

and Data for Domes Using the

Base without I/O Board

Check LEDs to verify that power and data are

reaching the dome (

Figure 39).

IMPORTANT! To view the LEDs, you will need to

detach the dome from its base. To prevent damage

to the dome, hold the dome by its housing, not its

eyeball assembly.

a. If the power LED (CR33) on the I/O board

glows green, then ac power is connected.

b. Green CR2, red (CR3), and yellow (CR4)

LEDs surround the video connection and are

visible through opening. Check that the

following communication protocols are properly

wired by observing these LEDs.

Figure 39. Cable connections (Manchester

requires separate cables for data and

power)

9-pin plug

LEDs CR2,

CR3, and CR4

visible through

opening.

4-pin plug

1 2 ... 31 32 33 34 35 36 37 38

Sin comentarios

American Dynamics RAS916LS-1 Especificaciones Pagina 36