American Dynamics AD1981 Especificaciones descargar pdf (Pagina 24)

Using the AD2079 in Operate Mode

3-5

2. Press the ACK key.

If the monitor is sequencing multiple alarmed video inputs,

hold

or step to (using the

last

keys) the appropriate alarmed video input, and press the ACK key to clear the alarm. Continue to

step to and ACK each alarm until all appropriate alarms have been cleared.

Alarm signaling capability will vary depending on which switching system is connected to the

AD2079. Consult your switching system manual to determine the particulars of the alarm interface.

Viewing Satellite Sites

site

is a complete matrix switcher / controller system, providing both local and remote control of

resources in a satellite network. If your workstation supports satellite site switching capabilities,

the SITE key accesses satellite sites.

To gain access to a satellite site:

1. Enter the site number on the numeric keypad. The site number will appear in the ENTER

display.

2. Press the SITE key. The site number will appear in the SITE display. The ENTER display will

clear.

3. Call remote site monitors and cameras by the procedures discussed earlier in this chapter (see

page 3-1).

Running Patterns

A pattern is a sequential series of pan, tilt, zoom, and focus commands defined for SpeedDome

series domes. A pattern is programmed in

real time

, which means that the dome remembers each

pattern segment in the actual time it takes the operator to execute a command. For example, if,

during a pattern sequence, the dome focuses on a door for 30 seconds, the door scene will appear

for 30 seconds when the pattern is called to run. Patterns are set in the Program mode, which is

discussed in the following chapter. Patterns are run in the Operate mode. Note: pattern command

sequences can vary depending on the switching system and accessories used. Consult the

appropriate product manual(s) if necessary.

To run a pattern:

1. Call the camera that the pattern will run on (see page 3-2).

2. Enter the pattern number on the numeric keypad. The pattern number will appear in the

ENTER display.

3. Press the PATRN key (P-1, P-2, or P-3 appear in the ENTER display) and then press the RUN

key. The camera will sequence through the pattern movements once.

To repeat a pattern:

1. Follow the procedure described immediately above to run a pattern.

2. After pressing the PATRN key(P-1, P-2, or P-3 appear in the ENTER display), press the ACK

key to repeat the pattern.

To hold a pattern:

1. Follow the procedure to run a pattern.

2. After pressing the PATRN key, press the HOLD key to bring the camera or dome to the

starting point of the pattern and hold there.

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 49 50

Comentarios a estos manuales

Sin comentarios

American Dynamics AD1981 Especificaciones Pagina 24

Comentarios a estos manuales

Relacionado con productos y manuales para Los Sistemas De Control De Acceso De Seguridad American Dynamics AD1981