American Dynamics AD1981 Especificaciones descargar pdf (Pagina 26)

Programming with the AD2079

4-1

Chapter 4: Programming with the AD2079

This chapter provides step-by-step instructions for keyboard operations performed with the

keyswitch in the PROGRAM position. The chapter also includes a discussion of operations

available with the keyswitch set in the MENU position.

Using the AD2079 in Program Mode

When operating with the keyswitch in the PROGRAM position, you can set presets, scratch-pad

tours, and patterns. You can also arm and disarm monitors.

Setting Presets

To set a preset:

1. Call a monitor and camera to the keyboard (see Chapter 3).

2. Turn the three-position keyswitch to the PROGRAM position.

3. Using the joystick, move the camera to the appropriate position. Make the appropriate lens

adjustments.

4. Enter the preset identification number on the numeric keypad (the number appears in the

ENTER display).

5. Press the SHOT key (the ENTER display will clear).

Setting Scratch-Pad Tours

To set a scratch-pad tour:

1. Call a monitor to the keyboard (see Chapter 3).

2. Turn the three-position keyswitch to the PROGRAM position.

3. Enter "62" on the numeric keypad. Press the PROG key to clear any previously programmed

scratch-pad tour.

4. Enter the first camera identification number of the tour (the number will appear in the ENTER

display).

5. Press the CAMERA key (the ENTER display will clear).

6. Enter the appropriate

dwell time

number (1-60) on the numeric keypad (the number appears in

the ENTER display). Press the PROG key (the ENTER display will clear).

Repeat steps 3 through 6 until all the cameras in the tour have been programmed.

7. Press the RUN key to run the scratch-pad tour.

Programming Patterns

You can program up to three patterns per programmable dome. The length and complexity of a

pattern are limited by two variables:

• number of camera commands

• time

Each time you move the camera in any direction (with zoom, focus, or iris adjustments), you issue

a command to the camera. The three patterns for a dome can collectively consist of up to 98

camera commands.

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 49 50

Sin comentarios

American Dynamics AD1981 Especificaciones Pagina 26